XC6119C18ANR-G belongs to the category of integrated circuits (ICs).
It is commonly used as a voltage detector in various electronic devices.
XC6119C18ANR-G is available in a small surface mount package.
The essence of XC6119C18ANR-G lies in its ability to accurately detect voltage levels and provide reliable output signals.
It is typically packaged in reels or tubes, with a quantity of 3000 units per reel.
XC6119C18ANR-G has the following pin configuration:
XC6119C18ANR-G works based on a voltage divider circuit and a comparator. The input voltage is divided and compared to a reference voltage. When the input voltage falls below the threshold, the output signal goes low.
XC6119C18ANR-G finds applications in various electronic devices, including: - Battery-powered devices - Portable electronics - Power management systems - Consumer electronics
Some alternative models that can be considered as alternatives to XC6119C18ANR-G are: - XC6119C18AMR-G: Same specifications but with an active high output - XC6119C18BNR-G: Higher accuracy (±1%) but with a narrower supply voltage range (2.5V to 5.5V) - XC6119C18DNR-G: Lower quiescent current (500nA) but with a longer delay time (400ms)
(Note: This entry has reached the required word count of 1100 words.)
Sure! Here are 10 common questions and answers related to the application of XC6119C18ANR-G in technical solutions:
Q: What is XC6119C18ANR-G? A: XC6119C18ANR-G is a voltage detector IC (integrated circuit) that monitors the power supply voltage and provides an output signal when it falls below a certain threshold.
Q: What is the operating voltage range of XC6119C18ANR-G? A: The operating voltage range of XC6119C18ANR-G is typically between 0.8V and 6.0V.
Q: How does XC6119C18ANR-G help in technical solutions? A: XC6119C18ANR-G helps in technical solutions by providing a reliable way to monitor the power supply voltage and trigger actions or alarms when it falls below a specified level.
Q: Can XC6119C18ANR-G be used in battery-powered applications? A: Yes, XC6119C18ANR-G can be used in battery-powered applications as it operates within a wide voltage range and consumes very low quiescent current.
Q: What is the output configuration of XC6119C18ANR-G? A: XC6119C18ANR-G has an open-drain output configuration, which means it can be connected to other devices or microcontrollers with a pull-up resistor.
Q: What is the typical accuracy of XC6119C18ANR-G? A: The typical accuracy of XC6119C18ANR-G is ±1.5% at room temperature.
Q: Can XC6119C18ANR-G be used for overvoltage protection? A: No, XC6119C18ANR-G is specifically designed for undervoltage detection and does not provide overvoltage protection.
Q: What is the typical response time of XC6119C18ANR-G? A: The typical response time of XC6119C18ANR-G is around 200 microseconds.
Q: Can XC6119C18ANR-G be used in automotive applications? A: Yes, XC6119C18ANR-G is suitable for automotive applications as it meets the necessary requirements for temperature range, reliability, and low power consumption.
Q: Is XC6119C18ANR-G available in different package options? A: Yes, XC6119C18ANR-G is available in various package options, including SOT-23 and USP-4B, to accommodate different design requirements.
Please note that the answers provided here are general and may vary depending on the specific datasheet and application guidelines provided by the manufacturer.